Question
After building and exploring in Minecraft, I chose this sticky piston mob grinder to learn about redstone - which may have been a bit too ambitious, as I'm having problems with the loop which sends pulses to the sticky pistons.
I have set it up like this, and the circuit lights up when I step on the plate, and stays on constantly when I step off, until I break it by removing some redstone.
What I think should be happening when I step on the plate is that the circuit should activate, sending current round the loop, each time round sending a pulse out to the sticky pistons (which I'm fairly sure are wired up correctly, as they do move when they receive current) - and that this should continue, even when I step off the plate.
I've been fiddling around with this for 2 days, and just cannot figure out what I'm doing wrong. Any thoughts would be much appreciated!
Answer
The loop is called a "clock" -- searching for that might help. My guess would be try increasing the delay in repeater time and don't stand on the plate for very long. What you want is for part of the loop to be lit up so that moves through the repeaters and back around again. If it still doesn't work, try a different clock -- they're basically interchangeable.
Check more discussion of this question.
No comments:
Post a Comment